| TPS Check | Start by removing the seat. The Dealer socket is located on the left side of the bike
next to the seat storage area. Shown in the picture below. Fish it out using your fingers. It's a white six pin plug with a black dust cover. There is a little slack in the wire harness that allows you to bring it out in the open.   The two wires you need to jump to put the bike into dealer mode are the black/white wire & the white/red wire. A tool made for the job is available from Suzuki for about $13.00. Or you can Mullet the job by using a piece of wire.   Once you have jumped the correct wires, turn the ignition to on. Make sure that you are in neutral or the "check" light will not go out. After the diagnostic "Check" you should see this...  The bar should be in the center for correct TPS alignment. If it is a high bar (top) or low bar (bottom) you will need to manually adjust the Throttle Position Sensor. The 00 code indicates that there are no trouble codes in the ECU. If you get a code other than 00 refer to the Service Manual for an explanation of the code. |